![]() ![]() Once it’s burning away, you can slide it back into the hole, and screw the lid back onto the open bottle tip. Though technically you can light it while it’s on your face, that isn’t always the most comfortable thing to do. Once you are satisfied with the fit of the joint, you can spark it up using a lighter, and take a couple of puffs to get it going.Roll a joint and fit one end of it snugly into the hole in the lid of the gas mask bong.Now you are done, and it’s time to learn how to use it!.Take a drilling tool, and make a small hole in the center of the bottle lid.If it pokes you, isn’t wide enough, or has some other problem you can slowly trim it down until it hugs the sides of your face and chin as closely as possible. The lid should line up close to your mouth, and the sides need to rest comfortably along your skin. ![]() Remove the lid if you haven't already and try to slide the plastic sleeve under your chin and around the sides of your face.Now take a marker and trim out a rectangle along the side of the bottle, leaving the curved end where the chamber narrows.If they are curved than you will need to trim them down more so that they don't scrape you face as you put it on. Once you are finished the edges of the open portion should be flat and not curved in. Now you will need to flip the bottle upside down, and completely remove the bottom of it along the edge that meets the sides.Wash out the pop bottle and remove any stickers or labels.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |